OZ Lifting Products Tele-Pro davit crane
OZ Lifting Products’ patented Tele-Pro davit crane features an industry-first telescoping boom adjustment that can be moved in and out while under load. A ratchet screw jack allows the user to adjust the boom from horizontal to 45 degrees while under load and the 360-degree rotation of the crane allows a full range of motion. Smart latch technology at the boom/mast means no tools are required for assembly. A zinc-plated finish provides added corrosion protection. The Tele-Pro is available in 500-, 1,200- and 2,500-pound capacities. AC and DC electric winches are optional on the 500- and 1,200-pound models, or manual winch with drill drive adapter is available for all three models. The cranes are made in the U.S. and each one is individually tested and certified at 125%. 800-749-1064; www.ozliftingproducts.com
Patterson Manufacturing Davit Cranes
Give your operations a lift with Patterson Davit Cranes, available in ½-ton and 1-ton capacities. The low maintenance, easy-to-assemble design offers adequate reach to accommodate lifting large loads within tight spaces, and a boom that can be adjusted to nearly 45 degrees to allow for clearance over obstructions such as handrails. Built for durability, it comes standard with a hot-dipped galvanized finish and stainless steel hardware to prevent rust and corrosion in wet work environments. Following Patterson’s tradition of safety-focused innovation, the davit features a reliable brake to keep loads in position without creeping. For over 160 years Patterson has been a trusted supplier of winches, rigging, fittings and custom products for lifting applications. Patterson Davit Cranes are made in the U.S.A. and deliver on the company’s promise of helping businesses run safer, easier and faster. Find out how Patterson can improve employee safety and positively impact your bottom line. 800-322-2018 www.pattersonmfg.com/davit-cranes
Reed Manufacturing Guillotine pipe cutters
Joining the slimmed-down line of Reed Manufacturing’s Guillotine Pipe Cutters is the updated HPC4+ model. Weighing in at a trim 11 pounds, the tool cuts square on medium and high-density PE pipe used by water and gas utilities. Accurate cuts mean no facing is needed for electrofusion and only minimal facing for butt fusion joints. All aluminum construction results in lighter tool weight and greater rigidity. HPC4+ cuts through 1 1/2- through 4-inch HDPE, both DIPS and IPS. Aluminum rails and crosshead with hard anodized finish reduce wear on sliding surfaces. A durable, coated blade produces square cuts with no chips to clog valves and small openings. A slight taper on blade allows an unchallenging start to the cut and holds form for an impressive, straight cut. Blades are straightforward to sharpen or replace. 800-666-3691; www.reedmfgco.com
